Technical qualities of NiSSOT

The product is fully certified in the accredited laboratory of The Military Technical Institute of the Army in Vyškov Czech Republic, which obtained accreditation for the EU.

Coded radio signal uses frequency 433.92 MHz reserved for control systems operations within the Czech Republic and the EU (process analogous to remote car unlocking). It works at 80% of allowed capacity (max 10 mW) and this ensures that no product will get over the power limit even if the spread of the parametres of the components used during manufacturing has been considered. Even at the 80% of the allowed capacity, there is range approximately 50 metres in an area not covered with buildings, which exceeds the range of analogous systems significantly.

All the figures of electromagnetic compatibility (EMC), radio parametres (constancy in frequency), general and electrical security and other parametres have been complied and observed, which can be supported with the certificates from laboratory.
Radio frequency part (RF) stability is ensured by an accurate SAW filter and a laser calibrated receiver. The transmitter is supplied by a battery.

Code differentiability - 266 million – is the guarantee for two codes of transmitters that they will not meet and affect each other. There exist possibility of floating code, which ensures communication and the system then cannot be crossed, analogously to car locking.

Each standard receiver falls in the so-called family -no fewer than 16 transmitters, and it can be trained 13 other separate transmitters apart from this family, in total 29. Connecting is very simple, after pushing the button on the receiver and the following push of the button on the transmitter, the receiver retains it in the memory (analogous to PC mouse). The memory can be reset and the receiver can be set again to the transmitters. In the same way, one transmitter could be connected to any number of receivers.

The receiver is equipped with the function of bulb dimming so it is quite easy to set intensity of light that you need. You thus enjoy pleasant light, which does not dazzle you, and the electric power is saved, too. 
The receiver is also equipped with the timer so you can easily set the moment of switching off or the period of lighting after switching on. 
There is no so-called "zero zone" for the transmitter, so with its safe 12 V tension you may use it, for example, in the bath and there is no threat of electric current accident. You also protect your children on 100% with the system.

Very easy fitting of the system could be compared to connecting of a pendent lamp. The system is just inserted between the connecting cables and the lamp.

The system can be adjusted in a simple way (reprogramming by the producer) to another way of control, you may use, for example, a long button push in the function for switching off another receiver than that it communicates with while a short button push, and especially this means great flexibility. This can be realized with a microprocessor whose control program could be changed at random, thus the system performs different functions with the same hardware.

Technical commentaries to the test results:

>Technical commentary - protocol 6450-67/2003		(pdf-file 70 KB)
>Technical commentary - protocol 730-420/2003		(pdf-file 65 KB)
>Technical commentary - protocol 730-427/2003		(pdf-file 70 KB)
>Technical commentary - protocol 730-436/2003		(pdf-file 72 KB)
>Technical specification - Transmitter and Receiver		(pdf-file   9 KB)

 

<<< back